Essential details
Shipping:Ocean Freight
Product Introduction
Product Introduction: This series of equipment is a complete set of special equipment for hot melt reflective road marking paint mixing, designed as an integrated machine, which is characterized by uniform mixing, high efficiency, small footprint, saving time and effort, easy installation and maintenance, suitable for the production of high-speed roads, urban roads, railways, Bridges, culverts and other special requirements of the surface coating coating. Meet environmental requirements. Hot melt marking coating....
Hot melt marking coating mixer equipment features
The series of equipment for the hot melt reflective road marking coating mixed complete sets of special equipment, designed as an integrated machine, its characteristics have uniform mixing, high efficiency, small footprint, saving time and labor, easy installation and maintenance, suitable for the production of high-speed roads, urban roads, railways, Bridges, culverts and other special requirements of the surface coating coating, in line with environmental requirements.
Hot melt marking coating mixer working procedure
All kinds of materials are manually measured, put into the equipment for mixing, (special attention, the main material into the mixer through the elevator, oil into the mixer through the oil pump), the resin, industrial wax, sand into the mixer 1-2 minutes after adding the oil, (note: Refueling should be done 4-5 times), and then add titanium dioxide, the other powder all into the mix, mixing for about 8 minutes can be discharged. Repeat the operation successively for the next batch of mixed production.
Hot melt marking paint mixer safety matters
For your safety and the safety of others, please note:
For your safety and the safety of others, please note:
1. All electrical appliances must have leakage protection devices to ensure reliable grounding (or zero).
2. Do not put your head or hand into the equipment while working.
3. When the equipment is in operation, do not open the door, cover, inspection hole, etc.
4. All operating parts should be rotated (moved) in the direction indicated.
5. The unit should be installed away from the fire source (more than 10 meters), ventilated, dry, and fully illuminated indoors.
6. Do not use untrained personnel to operate, minors are prohibited to operate.
7. Non-professionals are forbidden to open, disassemble and install any equipment, let alone change the control circuit system.
8. Pay attention to the lubrication parts, check each shift, and add lubricating oil in time.
9. If any exception occurs, turn off the power in time and confirm that the fault is rectified before starting up.
10. If there is a sudden power failure, the material must be released before starting, and it is forbidden to start with material.
All kinds of materials are manually measured, put into the equipment for mixing, (special attention, the main material into the mixer through the elevator, oil into the mixer through the oil pump), the resin, industrial wax, sand into the mixer 1-2 minutes after adding the oil, (note: Refueling should be done 4-5 times), and then add titanium dioxide, the other powder all into the mix, mixing for about 8 minutes can be discharged. Repeat the operation successively for the next batch of mixed production.
Product details
